Biznas
»
Direct Support
»
AT&T Direct
»
Adding Touch Screens To Projects And Prototypes
Rank: Advanced Member
Groups: Registered
Joined: 5/20/2023(UTC) Posts: 3,075 Location: USA
|
Adding Touch Screens To Projects And PrototypesPublished 9/2023 MP4 | Video: h264, 1280x720 | Audio: AAC, 44.1 KHz Language: English | Size: 3.40 GB | Duration: 7h 41m Send and receive data from and to a touch screen, and learn to use the available GPIOs What you'll learn Adding a touch screen to a project on a developet board Sending and receiving data from and to the screen using UART Using the General Purpose Input Output (GPIO) pins of the screen as Input, Output, and PWM. Creating a custom animated gouge (animated battery level indicator) Receiving data to screen by creating a battery level indicator using the ADC of the development board and UART communications Sending UART data from the screen to the dev. board and from Dev board to a MIDI shield The screen used in this board is from Nextion, and the Dev board is Nucleo-64 from ST Microelectronics with 411RE microcontroller Requirements Familiarity with programming in C Familiarity with a development board and an IDE software to program it If you are no familiar with the above, then it is still an opportunity to understand the concept. Code:https://www.udemy.com/course/adding-touch-screens-to-projects-and-prototypes/
|
|
|
|
Biznas
»
Direct Support
»
AT&T Direct
»
Adding Touch Screens To Projects And Prototypes
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.