The traditional Ore Milling Equipment dust are mainly in a rubber dust ring mounted spherical bearing Department of crusher, and a water inlet pipe and a water outlet pipe by welding dust in the bearing seat, and is provided with a water proof device, to prevent dust from entering the spherical bearing caused by wear. However, the traditional way of dust prevention is not very ideal, and there are still some problems in the long-term use of the process.

When the crusher is broken, the moving cone rotates 18~20 times /min with the rotation of the eccentric shaft, and sometimes the speed is even synchronized with the eccentric shaft sleeve, as high as 300r/min, so the rubber dust ring is wearing very quickly.
When the gap between the baffle and the moving cone dustproof rubber dust ring is too large to 1.5~3.0mm, dustproof rubber dust ring loses the dust-proof function, a large amount of dust will be driven along the baffle into the cone dustproof water seal device, water tank and drain plug, the dust deposition in the water sealing groove.

When the pressure in the clean water pipe is large, the water flows into the tank through the oil bearing ring from the oil return pipeline of the spherical bearing, polluting the lubricating oil and influencing the use of the lubricating oil. Therefore, in this case, the water seal device should be removed and removed regularly, and the oil in the tank will be replaced. This not only increases the labor intensity of workers, but also causes a great degree of waste.

The traditional way of crusher dust many ills, there are many deficiencies, after improvement of dust removal methods Hongxing machine, not only to save water, increase the ore processing capacity, improve the crushing efficiency, but also save oil, reduce labor intensity. In order to meet the needs of the crusher dust protection, it also saves energy for the crusher users and creates greater economic benefits. It can be said to be the perfect way to improve the dust control system of the crusher.