1. Pressing the button 1 and the button 2 of the remote at the same time.
2.When the LED light of the remote turn off, release both buttons. Now the LED of the remote emits a quick flash every 2 sec.
3.Place the original remote control in front of the remote , at about 2-3 cm of distance (as shown in the picture below).
4.Press and retain pressing the button of the original remote control that you want to copy until the remote's led will change frequency of flashing (faster than before), as confirm of the correct copy of the code.
5.While the LED is flashing, press the button of the JH-TX162 where you want to store ,the remote'code just copied, until the led will turn off.
6.The copy has happened with success, verify on the automation the orderly functioning of the new remote control.
Note:
?If the LED will flash only 3 times and then will turn off, it means that the code hasn't been copied well. In this case repeat the operation from the point 1.
?The memory of the remote is completely re-writable.
?To duplicate a second button, repeat the operation from the point 1.
You can use this remote control on BFT,FAAC,GENIUS,LIFTMASTER,ALLMATIC,ACM,GENIE,DITEC,DOORHAN,GIBIDI,HORMANN,JCM,KING GATES,MHOUSE,MERLIN,NICE,O&O,NORMSTAHL,PECCININ,PRASTEL,PUJOL,SEAV,SICE,SOMFY.....
http://www.juhuitech.net