There are different patterns on the checkered steel plate such as 2 bar, 5 bar, finger bar,?diamond, hyacinth bean. Chequered plate is beautiful and skid resistant. So diamond plates are widely used in traffic, building, decoration and as base plate?for some machines.Commodity Skid Resistant Carbon Checkered Steel PlateThickness 2.5-12mmPatterns ?2 bar, 5 bar, finger bar,?diamond, hyacinth Bean, chrysanthemumGrade A36,ST37,Q235,Q195Tolerance Comply with standard or requirementsStandards GB/T700, GB/T712, GB/T4171Surface Mill finish, Black surface, As rolledHeat Treatment Hot rolled, Annealing, TemperedWhen iron is smelted from its ore by commercial processes, it contains more carbon than is desirable. To become steel, it must be melted and reprocessed to reduce the carbon to the correct amount, at which point other elements can be added. This liquid is then?continuously cast?into long slabs or?cast?into?ingots. Approximately 96% of steel is continuously cast, while only 4% is produced as cast steel ingots.?Anti-slip checkered steel plate and the ingots are then heated in a?soaking pit?and?hot rolled?into slabs,?blooms, or?billets. Slabs are hot or?cold rolled?into?sheet metal?or plates. Billets are hot or cold rolled into bars, rods, and wire. Blooms are hot or cold rolled into?structural steel, such as?I-beams?and?rails. In modern?foundries?these processes often occur in one?assembly line, with ore coming in and finished steel coming out.?Sometimes after a steel's final rolling it is heat treated for strength, however this is relatively rare.?Thick steel plate steel and steel sheet substantially the same.?In all aspects, in addition checkered steel plate to the bridge plate, boiler plate, automotive steel, pressure vessel steel plate and multilayer high pressure vessel steel and other varieties is thick plate, some varieties of steel such as automobile beam steel plate (2.5 ~ 10 mm thick), decorative pattern plate (2.5 ~ 8 mm thick), stainless steel, heat-resistant steel and other varieties with thin cross.The other, diamond steel plate and the material of steel, not all of the steel plate are the same, material is different, the steel plate used, also not the same.With the development of science and technology and industry?for checkered steel plate, puts forward higher requirements on materials, such as higher strength, high temperature, high pressure and low temperature resistance, corrosion resistance, abrasion and other special physical and chemical performance requirements, the carbon steel can not fully meet the requirements.
http://www.yxysteel.com/steel-p...eckered-steel-plate.html